The Barmesa grinder pump is built to handle the rigors of Municipal and Industrial lift stations. With flow ranges from 10-108 GPM and heads to 160 feet these pumps will get the job done.
Cutter and shredding ring are made from hardened 440C Stainless Steel Rockwell C-55. The 10 vane impeller is a vortex type with pump out vanes on the back side for balance and to aid in pumping.
All Motors are 3450 rpm, Oil filled with Class "F" insulation.Single phase units are permanent split capacitor motors so you do not need to install anything in the control panel, 230 volt only.
Three phase motors are Nema "B" and available in either 230 or 460 volt.
All units include 25 foot cord and a humidity sensor which requires a relay in the panel. These pumps are also great where higher heads are needed to reach or feed a pressure main.
Use these pumps on a rail system, or as a stand alone.