Koshin Submersible Dewatering Pump


Click to Enlarge

 

PUMP OVERVIEW

Koshin built the PX pump to handle the rigors of daily use.  This is an ideal pump for use in excavations during the repair of water mains or for pumping out manholes or well casings.

The top discharge design means this pump will fit into smaller spaces than most side discharge units.  The blended rubber casing and impeller offer 3 times the wear resistance of cast iron, plus it is lighter in weight at only 24 lbs.

The 1/2 horsepower motor is cooled by the liquid flowing around the motor on the way to the discharge.   The motor is thermally protected, so if it should overheat, it will shut down before the motor is damaged.  The discharge is 2" NPT (M) and can be rotated from vertical to horizontal in about 2 minutes.

 

Parts Breakdown
or
Spec Sheet

SPECIFICATIONS:

  • Pump: Submersible Dewatering/Sump

  • Materials: Blended rubber case

  • Shaft Seal: Silicon/Carbide-double mechanical in liquid paraffin - environmentally friendly

  • Impeller: Blended rubber

  • Maximum liquid temperature: 104 degrees

  • Motor: 1/2 HP, air filled, 20' cord with 3 prong plug

 

PURCHASE KOSHIN PUMP

ITEM NUMBER DESCRIPTION PRICE

QTY XKOPX65011

1/2 HP, 115 Volt, Single Phase, 6.5 Amp Submersible Dewatering Pump
$363.00