Already widely used throughout the United
States and Canada, the LPD-250 is the easiest to use dechlorination
device available. Simply fill the feed tube with tablets and the LPD-250
will do the rest. There is no chemical to mix and waste. The LPD-250 is
for use with chemically treated (4 ppm or less chlorine/chloramine)
potable water. For higher chlorine concentrations up to 300 ppm please
see our COMBO Kit which works with the
LPD-250 and gravity feeds liquid CAPTOR NSF into the LPD-250.
CHOICE of TABLETS
The LPD-250 uses either LPD-CHLOR™
tablets (contains Sodium Sulfite 81.3%) or Vita-D-Chlor™
Tablets (Ascorbic Acid- Vitamin C) that neutralizes the
chlorine/chloramines in the water that you are flushing. When using
LPD-CHLOR tablets, the LPD-250 consumes about 1 tablet per 2,500 gallons
- the feed tube should be topped off with additional tablets after each
increment of about 10,000 gallons of flow. Weighing 33 lbs., the LPD-250
is heavy enough to take the day-to-day abuse of flushing. You can flush
straight off a hydrant or attach a hose to point the flow where you want
it to go.
LOW or HIGH FLOW DECHLORINATION
The LPD-250 can handle flows from 200 to 1,250 GPM and hydrant pressures
up to 200 psi. For flows lower than 200 gpm, we recommend you use our
Low Flow Inserts which will
allow more water to run past the tablets, great for applications such a
pool draining. For flows higher than 1250 GPM, we recommend a hydrant wye
or you can use our
Manifold Systems to attach
up to 4 LPD-250's for up to 5,000 gpm output.
Hydrant wye's are available in 4"
or 4.5" NST and allow you to use 2 LPD-250's
off the pumper nozzle.
A new
diffuser for use with chemically treated (chlorine/chloramine) potable
water. The LPD-250 is rugged and simple to use. This diffuser uses
LPD-Chlor Tablets
Sodium Sulfite or
Vita-D-Chlor Tablets Ascorbic
Acid (with screen) and dissolves them into the discharge stream.
It can handle about 10,000 gallons between tablet recharge. Rated
for hydrant static pressure to 200 psi with flow rates up to 1,250
gpm. Is equipped with a pitot slot for measurement of discharge
flow rate as well as a LPD-Pitotholder to hold the Pitot in the optimal
position for readings. |